MSH

Articles

• Gear Fitting For DownWind Stand-Up Paddle foil performance
  27 August 2025, by YJ

  The purpose of this study is to adapt the equipment of a
  professional DownWind (DW) Stand-Up Paddle (SUP) Foil
  Athlete Erwan JAUFFROY who had a creasy challenge in
  mind: Crossing –thanks to a hydrofoil (sort of small airplane)
  under is board- the 250 km distance between TOULON and
  CORSICA Island (Figure 1-a). But without any engine or sail
  (The FOIL CROSSING CHALLENGE). The goal is to
  minimise energy consumption, with an emphasis on his lower
  limb muscles.

• Multiscale characterization of an in-situ foamed 3D printed lightweight structure for the design of a complex digital twin
  26 June 2025, by YJ
• Caractérisation d’un acide polylactique (PLA) pour la fabrication additive d’une planche de surf innovante
  30 June 2024, by YJ
• Development of a 2-axis compliant joint for the orientation of payloads on small satellites: Material characterization and finite element analysis of 3D printed PolyEtherKetoneKetone (PEKK) and PolyEtherEtherKetone (PEEK)
  26 June 2025, by YJ
• Instrumentation of a controlled-manufacturing surfboard during surfing in order to quantify the influence of ’flex’ in the overall performance of the match athlete-board
  26 June 2025, by YJ
• AN UNDERWATER COMPARISON STUDY BETWEEN COMETA INERTIAL MEASUREMENT UNITS (IMU) & QUALISYS MOTION CAPTURE SYSTEM FOR LOWER BODY KINEMATICS DURING FREEDIVING
  16 December 2025, by YJ
• Aging effects at room temperature and process parameters on 3D-printed poly (lactic acid) (PLA) tensile properties
  16 April 2024, by IM
• The Development of a 3D-Printed Compliant System for the Orientation of Payloads on Small Satellites: Material Characterization and Finite Element Analysis of 3D-Printed Polyetherketoneketone (PEKK)
  17 April 2024, by IM
• Mechanical Structures & Human-structure interaction (MSH)
  16 July 2024, by IM

  The mechanical behavior control of structures or products, allows to optimize them to meet the specific requirements of extreme environments such as the marine environment. In addition, the ability to take into account the interaction between man and structure improves the structures or products compatibility and a help to their choice. Design and dimensioning of 3D printed structures (polymer or composite structures) for extreme environments such as the marine environment. Experimental and (…)

• Design and Fabrication of a 3D Printed Compliant System for the Orientation of Payloads
  5 February 2024, by LB